I have a Lexium drive (LXM05BD10M2) that I'm replacing due to occasional overheating with another 05B but when I go to run the motor I get the "parameter" error on the siemens plc. The only difference in the drives is the firmware versions and schneider-electric claims that should not be an issue. The config files in powersuite match so I don't understand what parameter is out of range.
I new to siemens but when I look at the FB's all of the read parameters just displays the same for multiple drives so I don't know what the actual parameters that are coming back to the plc.
So I was wondering if anyone has seen this or might have any ideas on how to solve this or how to figure out what parameter is wrong.
I new to siemens but when I look at the FB's all of the read parameters just displays the same for multiple drives so I don't know what the actual parameters that are coming back to the plc.
So I was wondering if anyone has seen this or might have any ideas on how to solve this or how to figure out what parameter is wrong.