The main device is a TBox CPU32 with a 'spankin new' df1 driver add-on. The manual from that only lists 3 or 4 error codes, other than that I assume there's some standard for the df1?
Also, as Ken mentioned, I'm using df1 via message instructions. The instructions originate from a CLX, and are being sent to SLC 5/03. I have CIP datatable read/write messages to a FlexLogix.
The slc message
flags register came back HEX0210
The error register showed HEX001F
I don't know what this is but
the EXERR register showed HEX0000_0204
The Flex message
flags register showed HEX0210
error register showed HEX0004
and the EXERR showed HEX0000_0000
problem is: I don't have a table showing what these errors mean, making it difficult to troubleshoot, whats more, if I fault that SLC, I could loose my job.
for more information on the setup, please refer to
http://www.plctalk.net/qanda/showthread.php?t=45068&highlight=clx
and
http://www.plctalk.net/qanda/showthread.php?t=44906&highlight=clx
I would like to note that one of the slc messages worked.
The df1-message to get the data from the output files and the timer files from the SLC 5/03 worked perfectly. However these slc messages that are in error are to a different slc.