Hello guys,
I've been using STEP 7 v5.3+HF2.
I tried to open one STEP 7 project that was sent to me. When opened, I saw the windows "Modules which cannot be displayed with by the installed version of STEP7: (Status= X: HW Update available).
I have downloaded HW Updates from the Internet (it took a while), but still cannot open CP 343-1. Is it possible that version is too old? In the same table I can see that version is STEP 7 v5.4 SP1.
That is odd. Why do I have to have newer version to open properties of the hardware? Why HW update is not enough?
Thanks
I've been using STEP 7 v5.3+HF2.
I tried to open one STEP 7 project that was sent to me. When opened, I saw the windows "Modules which cannot be displayed with by the installed version of STEP7: (Status= X: HW Update available).
I have downloaded HW Updates from the Internet (it took a while), but still cannot open CP 343-1. Is it possible that version is too old? In the same table I can see that version is STEP 7 v5.4 SP1.
That is odd. Why do I have to have newer version to open properties of the hardware? Why HW update is not enough?
Thanks