Hi Guys,
I am going to be using a Floboss 107 and tie in a couple of turbine meters. I looked at the wiring diagram for PULSE inputs in the manual and it does not show any resistor requirement. Can you just wire the points (PI/GND) straight to the meter without any resistors?
Also, typically are these resistors are requirement for the end device or for the pulse card?
I am going to be using a Floboss 107 and tie in a couple of turbine meters. I looked at the wiring diagram for PULSE inputs in the manual and it does not show any resistor requirement. Can you just wire the points (PI/GND) straight to the meter without any resistors?
Also, typically are these resistors are requirement for the end device or for the pulse card?