Help. My oc211 isnt work with cj2m cpu35

Hi ihave plc cj2m cpu35 with module input id232 and output oc 211
When i try my program with cx programer. The input in the program is work and green line to go to the coil. But the center on the coil not green (grey). Input module led is on but led from oc 211 is off.
When i force it is work and led oc211 is on it work and it became like it supposed to be normally onn cx programer.what the problem. Thanks

Make sure the plc is in either Run or Monitor mode.
From your description, sounds like the plc is in Program mode.

My plc is in run mode.

Couple of things to check.


Do a compare of the plc code and your CX-Programmer program.
From the PLC pull down go to Transfer, then Compare.


Are there any Interlock (IL) or Jump (JMP) instructions in your program?

gtsuport said:

Couple of things to check.


Do a compare of the plc code and your CX-Programmer program.
From the PLC pull down go to Transfer, then Compare.


Are there any Interlock (IL) or Jump (JMP) instructions in your program?

Click to expand...

Mr gt. I hve tried to make a new simple program with 1 input and 1 output and upload to plc cpu 35 but even that dosnt work. And i tried with a different plc is cj2m cpu12. And my program work. If i use cpu35 on the cx programmers in my program line will be green but the coil (internal relay or basic relay) is not full green (the circle line is green but on the center circle is gray) It is different from using a CPU 12, the green light on the coil will be full on the circle coil in cx programmer

Post here the project with this simple program.
And by the way, transfer to the PLC is called download, not upload.

Solved

solved. coil end001 which causes it to not work

Thx all