Help with AB micro820 ccw

newjersey1000

Member
Join Date
Aug 2017
Location
New Jersey
Posts
3
Hello

I am programming AB micro820 with CCW. I need to connect a bander to an output and the bander can only work once even if the output stays ON. What can I use in CCW ? I think I have to use pulse rising edge coil for that output but I am not sure.

Thanks again
 

Similar Topics

Hello all! I come asking if anyone has had this situation. I have a Micro820 controller that sits idle for some long periods (I use it to count...
Replies
5
Views
1,276
Hey everyone, I'm pretty new here, but have been working lightly with AB PLCs for a while now. I've recently hit a stumbling block that I'm hoping...
Replies
4
Views
1,326
I have a Micro820 here that will eventually be used as a slave device and will have information pulled from it serially. I need to test the...
Replies
14
Views
4,412
so i have a micro 820 for a small project im working on and im having a **** of a time figuring out how im going to get a retentive timer to pick...
Replies
7
Views
2,578
Hello. I am beginner plc programmer working in a project at work using micro820 and CCW. Every time a modify the program I have to download the...
Replies
6
Views
3,481
Back
Top Bottom