mike3475
Member
Hi, Expert:
Is there any possible MAM PC bit turning on before reaching the position?
Thanks!
Is there any possible MAM PC bit turning on before reaching the position?
Thanks!
Last edited:
Kinetix6000 MAM PC bit question
- Thread starter mike3475
- Start date
aawilliams85
Member
If I recall correctly, the Position Complete bit should be set when the actual position reaches final position within the Lock Tolerance value.
Similar Topics
Hello,
I got E62 on Kinetix6000 servo drive.
I have checked feedback cable end to end all are good connection.
There are 9 wires connected.
In...
Regarding sercos motor control I am a complete novice so i'm a little out of my depth here.
My issue is that I have 4off kinetix6000 servo drives...
What would be the reasons why the IAM module would open the contact for the Contactor Enable Relay (CED) on a Kinetix6000 drive.
This is...
Hello,
we are using mpl-8330p-sj24aa as a conveyor servo with kinetix6000 guard motion.And our plc platform is control logix5573.The conveyor is...
on one machine,roller circumference is 50cm,the gear ratio is 15:1.and driver is kinetix6000.i want realize the function is:
if i write 5 in the...