“GO” command in Fanuc robot program?

wendaiyu

Member
Join Date
Jun 2014
Location
toronto
Posts
87
Hi, folks.

Plz check the attachment. On line 71, there is “GO” command.

Could you tell me what its meaning and function is?

Thanks a lot.

GO.JPG
 
Hi, folks.

Plz check the attachment. On line 71, there is “GO” command.

Could you tell me what its meaning and function is?

Thanks a lot.

It means Group output... So they're setting an Integer to 100 (or whatever it equaled) in that instruction

If you press config, it will show you where it is mapped to.
 

Similar Topics

S
Hi All, Can anyone give me some information on the GE Fanuc Series SIX COMM BLOCK instruction please. The full rung has this form: O1021...
Replies
5
Views
5,454
SkinniMT
S
Hello guys, I am new to this forum and have some problems with my PowerFlex755 EENET frequency inverter. I want to do a point to point...
Replies
0
Views
43
I have an issue with Power Flex 525 during running processing, the VFD stopped suddenly while the PLC and VFD connection ok, VFD does not have any...
Replies
1
Views
89
Hi, I have been trying to run drive via Sysmac studio. I can ping the drive. I can see the logic bits going on/off as per command. But, drive is...
Replies
21
Views
469
Word of warning. I had issues with a 5069-AENTR not appearing in IO selection. After downloading the latest version 40 AOP, still didn't appear...
Replies
0
Views
125
Back
Top Bottom