I have 16 cb_E connected to OP16 via fiedbus and the cb-E connected to l60 controllogix via en2t ethernet. using generic module in IO config so I can send setpoint, see weight, rate etc. I do not know why and cannot verify but operator said parameters like fill min,max are gone after I download the clx. I dont have write command to said parameters in clx but it is possible to do so. they tend to calibrate via op16 so its not applicable to do it via plc. any thoughts?
sidenote-
16 cb -e took a toll in the network, if I edit in rslogix, there is 1min hang in operator hmi.
sidenote-
16 cb -e took a toll in the network, if I edit in rslogix, there is 1min hang in operator hmi.
Last edited: