PowerFlex 40 Comm loss

icehube

Member
Join Date
Nov 2005
Location
ohio
Posts
86
Quick question guys, I have a powerlfex 40 drive that intermittenly show an F081 fault...it clears and runs but comes up every once in while. This is connected to controlnet and the A105 parameter is set to (0) which fault. which one turns this off?
 

Similar Topics

Good Morning , I just recently did a project with several PowerFlex 525 drives. I just recently started getting a F 73 Fault ( EN Net Loss...
Replies
24
Views
23,936
Processor is a L32E For some reason, I thought that there was a tag member that would give a status on Ethernet communications for a powerflex...
Replies
25
Views
15,337
I have 3 new PowerFlex 7000 VFD's. Rockwell was out to do some checking before startup. These are part of a larger electrical project. I gave the...
Replies
7
Views
276
Hello all, new here. I have 16 Powerflex 40’s that I am converting from DeviceNET to Ethernet. I changed all of the Comm modules to 22-COMM-E and...
Replies
3
Views
1,091
I've been talking with PowerFlex 525 Drives using the Comm C module with a non rockwell controller without any issues. I went ahead and loaded...
Replies
3
Views
977
Back
Top Bottom