heroek Member H Join Date Jun 2013 Location italy Posts 2 Jun 26, 2013 #1 Dear Sirs, i have a problem with my micrologix 1400 with analog input 1762 if4 . I have set the hardware jumper for Volt and i added the module 1762 to rslogix micro configuration as in picture . But i don't see nothing in the input table , all zero instead of a value . What can i do ? Thanks
Dear Sirs, i have a problem with my micrologix 1400 with analog input 1762 if4 . I have set the hardware jumper for Volt and i added the module 1762 to rslogix micro configuration as in picture . But i don't see nothing in the input table , all zero instead of a value . What can i do ? Thanks
Jean-Luc Member J Join Date Aug 2011 Location Curitiba Posts 39 Jun 26, 2013 #2 The images show that you are in Remote Prog mode. Did you try to go in RUN mode ?