Hi Guys
Took over a job where the customer has VLTmicro fc51 drives. Im installing a plc to control them so I would need a digital input from them telling me if they are tripped. I have never used these drives before
There is no relay outputs on these drives. The only thing I found in the manual is that you can switch the analog output to a digital output via paramater 6-90 and 6-92. I have done this but still dont get the contact to react. Just get a permanent 18Vdc out.
Is there any other settings you guys know of?
Thanks for any advice
Took over a job where the customer has VLTmicro fc51 drives. Im installing a plc to control them so I would need a digital input from them telling me if they are tripped. I have never used these drives before
There is no relay outputs on these drives. The only thing I found in the manual is that you can switch the analog output to a digital output via paramater 6-90 and 6-92. I have done this but still dont get the contact to react. Just get a permanent 18Vdc out.
Is there any other settings you guys know of?
Thanks for any advice