Thanks
you right, getting use to it is the most important.
I have used the omron myself for about 20 years, but have did any projects that required using analog inputs or outputs. our former boss had this thing that anytime we wanted to control temperature we used a omron temperature controller and just had the plc control if it was enabled and suppose to work. About 3 years ago, got a new boss and behold, everything new now had to be done with allen bradley, and have done some ab project using analog inputs and outputs to control pressure and maintain level etc., used the scp and the pid instruction with the micrologics and slc500 series.
Now we getting in quite a bit of new equipment, and havin to now take over and maintain equipment in asia and euroupe, and it is all omron with cj1m plc's, and just trying to get back to understanding them. Everything in our plants is either cqm1h or c200. We have hundreds of cqm1h, so not too familiar with the new omron plc's. And we stilol using mostly syswin since all the techs in our plants have the license and the cqm1h the plc's we have and support.
I now trying to figure out how to take a ultrasonic sensor into a omron cj1g-h plc with a cj1w-mad42 analog card that one of the analog outputs is not being used. it is in rack2, slot 5. The analog input that i will need to look at is already being used with the apr instruction, but i need to figure out how to take that input and scale it and then use it in a pid to control the level of liquid in a wastewater pit by controlling the speed of a vfd drive. Looks like i have a lot of reading to do.