I am trying to set up the communication between a SLC 5/05 and a Schneider ATV71 drive with an Ethernet I/P communication module. I believe this would be classified as a Generic Ethernet I/P device. I only want to read a few parameters from the drive, not control the drive.
I am having trouble figuring out what should be programmed into the Message Block for the Service, Class, Instance and Attribute. I cannot find any information on what is required. If anyone could point me to some information or give me an example of this type of message, I would be grateful. I have all the applicable manuals but they don't seem to have the information I need.
Thanks
I am having trouble figuring out what should be programmed into the Message Block for the Service, Class, Instance and Attribute. I cannot find any information on what is required. If anyone could point me to some information or give me an example of this type of message, I would be grateful. I have all the applicable manuals but they don't seem to have the information I need.
Thanks