thank you for your quick answer^^
yes of course i read this pdf !
i even printed it out :
but there is no final answer for me .. its like a big "?".
so i first i need to check how a rs232 - cable is wired. then i have to look if the programming-cable has the same wires.
(sry bad english)
i think i cant buy this anymore.. maybe hard to find
hmmm...
Page: 3-8
PGU port D-Sub socket, 9-pole1)(for PCD8.K111 programming cable) 1
1) Can also be used as a serial data port, e.g. to connect a terminal; but this hampers troubleshooting with the debugge
page 4-5
The PGU interface (Port # 0) is connected to a 9-pole D-Sub connector (female). The interface is used to connect the programming device when the unit is comissioned.The interface is of type RS 232c.
PCD8.K111 connecting cable(P8 and S-Bus protocol, suitable for all PCD1 / PCD2 units