ALlen Bradley 931N Signal conditioners

Prankzbhardwaj

Member
P
Join Date
May 2020
Location
California
Posts
1
Hi,
I am trying to connect several 931N-T221 to Logix 5000 PLC ( 1756-IF8 module) going over the documentation, I found that it can support both differential and single ended inputs. But I am not sure about 931N series conditioner, they are not loop powered but I am not sure if I should use them as Single ended of Differential input to the module.
Any suggestions?

Thanks :)
 

Similar Topics

R
Allen-Bradley Analogue Input 1756-IF16 Scaling
Hi, I have a ControlLogix system with 1756-IF16 analogue inputs. I can't scale the inputs at the card as there is a requirement to facilitate...
Replies
2
Views
35
OkiePC
OkiePC
G
Allen-Bradley visualization architecture (SiVArc analogue)
Dear community, I am trying to find a tool for Allen-Bradley PLCs similar to SiVArch for Siemens PLCs to automatically generate faceplates and...
Replies
0
Views
42
Gunman
G
D
Allen Bradley 1734-AENT issue
Hi everyone, new to forum. Since very long time i having issue with 1734-AENT module, after some period of time its keep stuck in error (simmilar...
Replies
5
Views
228
dummy_bit
dummy_bit
K
Places to sell surplus Allen Bradley PLC's and various other items
Hello, I am new here. I am trying to find good places to sell some surplus items that I have that isnt through ebay. Does anyone have any sources...
Replies
5
Views
334
tlf30
tlf30
H
A/I module 1756-IF16 Allen Bradley
Hi all, installed on chassis A17 an A/I from Allen-Bradley , problem is what ever I do , all channels are sticked on value 39.9 and cannot change...
Replies
1
Views
132
dummy_bit
dummy_bit
Back
Top Bottom