UInhandled exception was raised

Hello everyone... I have a problem and i want your help.

I installed Wincc V7 SP1 &SP2. The installation was done normally without any problem.

However, when i open the program and load it, it starts normally as usual, but in the end it gives me the following message (i attach screenshots and the log file)

Unhandled exception was raised. Look file "script.log" for details.

Am i doing something wrong?





View attachment SCRIPT.txt

Check the response and link from "bg2492" in the following thread on the siemens forum.

https://support.industry.siemens.co...-on-wincc-v-7-0-3-2/154534?page=0&pageSize=10

I hope these can help you to find the right direction:

https://support.industry.siemens.co...05-access-violation/83309/?page=0&pageSize=10

https://support.industry.siemens.co...-on-wincc-v-7-0-3-2/154534?page=0&pageSize=10

Can you zip your WinCC application folder and post it for me to have a look?