Kevbloke020471
Member
Hi All
Im trying to connect to E100 using CAB5 cable and e designer software but cant seem to connect.
The PLC is a FX1N connected.
The software when set up gives me version 4 or 6 for the HMI. I have tried both but no joy.
I have used all baud rates and still no joy.
Is there something in the HMI that i have to enable? Ive read the manual and this said i shouldnt need too but its a bit ambiguous.
Any help will be much appreciated.
Thank you
Kev
Im trying to connect to E100 using CAB5 cable and e designer software but cant seem to connect.
The PLC is a FX1N connected.
The software when set up gives me version 4 or 6 for the HMI. I have tried both but no joy.
I have used all baud rates and still no joy.
Is there something in the HMI that i have to enable? Ive read the manual and this said i shouldnt need too but its a bit ambiguous.
Any help will be much appreciated.
Thank you
Kev