Hi all,
I have an slc 5/05 and am trying to read data from an 193-etn using the eem instruction as described in the instruction, but I cannot get it to work.
I keep getting a message error 15h too much data. I have the IP address set up and can ping the slc and the 193-etn.
The slc firmware is version 13 and I’m using rslogix 500 version 9.00.
Any help would be greatly appreciated.
I have an slc 5/05 and am trying to read data from an 193-etn using the eem instruction as described in the instruction, but I cannot get it to work.
I keep getting a message error 15h too much data. I have the IP address set up and can ping the slc and the 193-etn.
The slc firmware is version 13 and I’m using rslogix 500 version 9.00.
Any help would be greatly appreciated.