idiotsecant
Member
Is it possible to configure an Allen Bradley panelview 1000 series to be a modbus RS485 slave? I guess I am not certain exactly how/if that would work, the Allen Bradley documentation all seems to assume that you will configure the HMI to be a master.
I am attemping to interface three panelview 1000 series HMIs onto a single serial bus to communicate with a Honeywell safety system - I have to use serial as the ethernet ports are all dedicated to various safety links and cannot carry my lowly HMI traffic. As far as I know all three HMIs will want to be master on the bus, Does anyone know if is there any way this can work?
Thanks
I am attemping to interface three panelview 1000 series HMIs onto a single serial bus to communicate with a Honeywell safety system - I have to use serial as the ethernet ports are all dedicated to various safety links and cannot carry my lowly HMI traffic. As far as I know all three HMIs will want to be master on the bus, Does anyone know if is there any way this can work?
Thanks