BiteBytesButes
Member
Hi Gents,
I am here with an 1756-L73 with a partner 1756-L7SP.
This is for an hydraulic press machine, with an very critical scan.
I need your help to clarify the following:
The values below, comes from the Properties>Monitor in each Task.
The current Motion Scan is 0,5ms, and 10ms for the Base Update Period.
The Safety routine has a scan time of 7ms.
The Continuous and only the task in the code has 42ms of scan time (Main Task).
The System Overhead Time Slice is 50%.
They do not use any Periodic Task.
So, my question is: When is executed the background routines, as communication?
Should be after the Main Routine 42ms, but....I do not know if this can run with System Overhead Time Slice at 50%.
I think that the Main Task ( the only task in the code), it is interrupted several times.
I cannot use the Task Monitor to confirm this above because I am using the RSL5K version 31.
Any help?
thank you!
I am here with an 1756-L73 with a partner 1756-L7SP.
This is for an hydraulic press machine, with an very critical scan.
I need your help to clarify the following:
The values below, comes from the Properties>Monitor in each Task.
The current Motion Scan is 0,5ms, and 10ms for the Base Update Period.
The Safety routine has a scan time of 7ms.
The Continuous and only the task in the code has 42ms of scan time (Main Task).
The System Overhead Time Slice is 50%.
They do not use any Periodic Task.
So, my question is: When is executed the background routines, as communication?
Should be after the Main Routine 42ms, but....I do not know if this can run with System Overhead Time Slice at 50%.
I think that the Main Task ( the only task in the code), it is interrupted several times.
I cannot use the Task Monitor to confirm this above because I am using the RSL5K version 31.
Any help?
thank you!