PhysicalAxisFault at Kinetix 6000

mike3475

Member
Join Date
Feb 2013
Location
brooklyn ,NY
Posts
329
Hi,Guys:
we got issue with Kinetix6000 servo drive with E06 (HardOverTravel Fault),
I saw "AS_Axis06.PhysicalAxisFault" showing 1 at monitor tag of Studio 5000 when Kinetix6000 servo drive shuts off with E06.
should I change the physical travel limits for this servo drive to make its travel range a little bigger?
thanks!
 
You should not cross the hard limit unless something has gone horribly wrong, the axis travel is badly designed, or the sensors are in the wrong position.
 

Similar Topics

Hi All, I have a 2097-V31PR0-LM Kinetix 350 and a TLY-A110T-Hxx2 servo. It is a new setup and I've commissioned the drive: Scaling, hookup tests...
Replies
12
Views
20,659
Hi guys! I have 3 servos for X,Y,Z axis controlled by Kinetix 5500. In Studio 5000 there is one Predefined tag in AXIS_CIP_DRIVE called...
Replies
0
Views
2
Hello. I have a few machines that use Kinetix 300 (each machine has two drives). Both drives on one of the machine keep losing IP address. They...
Replies
2
Views
75
Dear colleagues, hope you can help on that matter. We have a project where we need to control 3 servomotors to move a auger feeder system...
Replies
38
Views
809
Loving AB right now... We have an Allen-Bradley 2094-EN02D-M01 Kinetix 6500 servo drive that once had safe-speed monitoring which was eliminated...
Replies
2
Views
90
Back
Top Bottom