geniusintraining
Lifetime Supporting Member + Moderator
Hello,
Does anyone know how to address a output word in CCW? I have done this with just about every other PLC made but no luck in CCW, I also tried making a RSLogix move from a timer ACC to a output word O:0.0 then used the conversion tool in CCW but it was the only part of my program that it could not convert, I asked the same question a few years back and did not get a answer but was thinking someone else may have needed it and found a work around?? ST maybe?
Thank you
Mark
Does anyone know how to address a output word in CCW? I have done this with just about every other PLC made but no luck in CCW, I also tried making a RSLogix move from a timer ACC to a output word O:0.0 then used the conversion tool in CCW but it was the only part of my program that it could not convert, I asked the same question a few years back and did not get a answer but was thinking someone else may have needed it and found a work around?? ST maybe?
Thank you
Mark