Hi,
I’ve been a long time reader, and now this is my first question...
I have a Telemecanique TSX17 PLC which I need to upload the code from, unfortunately the PLC has lost its sticker with the part number on it, hence no other details other than it’s a TSX17.
I have a laptop running DOS / windows 3.11, with the required serial port etc. Plus floppy drive.
My problem is finding software compatible with my laptop, that will install and (I assume) run in DOS. Can someone point me in the right direction? I’ve found limited information already out there, including a link to some software on the Schneider website, it might just be me being stupid, but I couldn’t understand how to install the softwar. My plan would probably be to transfer from a modern laptop to a floppy and then onto my old laptop.
Any pointers from someone experienced with these PLCs would be great, if it was an old Square D, or Texas I’d be fine, but this thing has got me stumped!
Thanks
Andy
I’ve been a long time reader, and now this is my first question...
I have a Telemecanique TSX17 PLC which I need to upload the code from, unfortunately the PLC has lost its sticker with the part number on it, hence no other details other than it’s a TSX17.
I have a laptop running DOS / windows 3.11, with the required serial port etc. Plus floppy drive.
My problem is finding software compatible with my laptop, that will install and (I assume) run in DOS. Can someone point me in the right direction? I’ve found limited information already out there, including a link to some software on the Schneider website, it might just be me being stupid, but I couldn’t understand how to install the softwar. My plan would probably be to transfer from a modern laptop to a floppy and then onto my old laptop.
Any pointers from someone experienced with these PLCs would be great, if it was an old Square D, or Texas I’d be fine, but this thing has got me stumped!
Thanks
Andy