Eberle 511

Please is it possible to copy the eproms of the eberle 511 to another same cpu?
will it work without any issues?
Please help and thank you.

http://www.plctalk.net/qanda/showthread.php?t=384

http://forums.mrplc.com/index.php?/topic/3019-telemecanique-tsx-21/

The above threads may help you out. If you copy the eprom then the controller should work.
This controller should be replaced with something that is at least supported. Do you have a copy of the program?

Regards,

NO, i am copying it from one unto another.
Thank you.