Hello,
I need to reconfigure some channels on an existing 1771OFE of a PLC 5/20E. All 4 channels are 1-5vdc right now.
I know I will need to pull the module to check and possibly change the jumper positions. Confirm if it's OFE2/3. And then do some reconfig via the I/O configuration and rack, slot, all that and select the appropriate current from voltage.
My question is, can some cards not be current output capable? Can I tell this from the module type? Aside from the jumpers and the module config via the I/O config in PLC, is anything else needed to complete this?
I've been referencing the very unhelpful PN955107-82 manual. Looking for more clear explanations/direction.
I get lost on not being able to see the BTW/BTR configuration setups and then working off of default configs in the I/O configuration.
Any insight is appreciated.
I need to reconfigure some channels on an existing 1771OFE of a PLC 5/20E. All 4 channels are 1-5vdc right now.
I know I will need to pull the module to check and possibly change the jumper positions. Confirm if it's OFE2/3. And then do some reconfig via the I/O configuration and rack, slot, all that and select the appropriate current from voltage.
My question is, can some cards not be current output capable? Can I tell this from the module type? Aside from the jumpers and the module config via the I/O config in PLC, is anything else needed to complete this?
I've been referencing the very unhelpful PN955107-82 manual. Looking for more clear explanations/direction.
I get lost on not being able to see the BTW/BTR configuration setups and then working off of default configs in the I/O configuration.
Any insight is appreciated.