Keldog
Member
I got a request at the sawmill i maintain. They have a bull edger that when a log is detected it brings the blades into 4" but they would like it to bring them to 3.5".
It moves a value into a Bit telling the piston how far to move the blades in.
1 = 3"
2 = 4"
4 = 5"
8 = 6"
Inorder to move it to 3.5, should i make a value of say 3 and divide it by 2 to get 1.5 Would that work?? Or is there a way to make a value of 3.5.
I know this probably sounds vague and i apologize it's hard to explain.
It moves a value into a Bit telling the piston how far to move the blades in.
1 = 3"
2 = 4"
4 = 5"
8 = 6"
Inorder to move it to 3.5, should i make a value of say 3 and divide it by 2 to get 1.5 Would that work?? Or is there a way to make a value of 3.5.
I know this probably sounds vague and i apologize it's hard to explain.