sparkytex
Lifetime Supporting Member
Hello guys,
I’m doing some new programming for our WWTP in town. I need to utilize existing SCADA tags for my new programming. I’m used to wonderware or RSView where there is an offline editor where you can choose which page you want to look at and click on the graphics and look at the PLC address associated with the graphics and HMI tag. It’s usually a lot faster than sifting through the PLC program.
The problem is I can only see the IFIX workspace run mode where it’s the online version for the operators. Looking for help on finding an offline version of each SCADA page so I can pull PLC addresses from them. Any help is greatly appreciated.
- Tex
I’m doing some new programming for our WWTP in town. I need to utilize existing SCADA tags for my new programming. I’m used to wonderware or RSView where there is an offline editor where you can choose which page you want to look at and click on the graphics and look at the PLC address associated with the graphics and HMI tag. It’s usually a lot faster than sifting through the PLC program.
The problem is I can only see the IFIX workspace run mode where it’s the online version for the operators. Looking for help on finding an offline version of each SCADA page so I can pull PLC addresses from them. Any help is greatly appreciated.
- Tex