I am modifying this program on a CJ1 Omron PLC.
CIO address 54 is under one MOV command that assigns it a value.
For the rest of the program that value is checked against other values with =(300)
However this address takes the value then start swinging between the assigned value and 0.
nothing else on the program is assigning a value to 54.
Is there a way to know where this assignment of 0 is coming from?
CIO address 54 is under one MOV command that assigns it a value.
For the rest of the program that value is checked against other values with =(300)
However this address takes the value then start swinging between the assigned value and 0.
nothing else on the program is assigning a value to 54.
Is there a way to know where this assignment of 0 is coming from?
