Ones_Zeros
Member
one more question
i could just read this final DINT tag value in wonderware. like you said if its a 4 the connection is good any other value its not.
would i need to use a compare instruction in the PLC to compare this value of 4 to turn a coil on & off & read this value into wonderware?
ON=Good
Off=Disconnected
thanks
i could just read this final DINT tag value in wonderware. like you said if its a 4 the connection is good any other value its not.
would i need to use a compare instruction in the PLC to compare this value of 4 to turn a coil on & off & read this value into wonderware?
ON=Good
Off=Disconnected
thanks
Last edited: