Hi,
I have used quite a few 1336 Impact & Yaskawa G5 drives on hoists. Used to always Inertia tune the drives on almost full load.
Just happened to read a few manuals of the present generation of drives that i could use for hoisting. Wherein its recommended to do the Inertia tuning on no load conditions.
I'm confused. Whats the right way to do so?
I have used quite a few 1336 Impact & Yaskawa G5 drives on hoists. Used to always Inertia tune the drives on almost full load.
Just happened to read a few manuals of the present generation of drives that i could use for hoisting. Wherein its recommended to do the Inertia tuning on no load conditions.
I'm confused. Whats the right way to do so?