AshleyParr
Member
Good evening all,
We have a couple of volumetric fillers at the brewery where I work. We monitor & weigh our bottles to ensure we are legally supplying the correct amount to the sonsumers. From these values we then change the volume fill settings on the filler. Abit of trial & error by the operators to be honest.
I remember a while ago someone said to a colleague that there is a way to fine tune this setting, something along the lines of entering the bottle data & it spits out a setting to try.
I can’t remember if this was a software solution from someone or just a formula. Has anyone here came across this before?
Cheers,
Ash
We have a couple of volumetric fillers at the brewery where I work. We monitor & weigh our bottles to ensure we are legally supplying the correct amount to the sonsumers. From these values we then change the volume fill settings on the filler. Abit of trial & error by the operators to be honest.
I remember a while ago someone said to a colleague that there is a way to fine tune this setting, something along the lines of entering the bottle data & it spits out a setting to try.
I can’t remember if this was a software solution from someone or just a formula. Has anyone here came across this before?
Cheers,
Ash