Mad_Poet Member M Join Date Feb 2017 Location Virginia Posts 375 Aug 22, 2017 #1 Anybody have any ideas as to what sort of hardware is needed to access a Lenze EPL 10200 PLC? And, what is a good software package for accessing and writing programs for the beast? Thanks, MadPoet.
Anybody have any ideas as to what sort of hardware is needed to access a Lenze EPL 10200 PLC? And, what is a good software package for accessing and writing programs for the beast? Thanks, MadPoet.
gclshortt Member Join Date Dec 2014 Location Ontario Posts 3,217 Aug 22, 2017 #2 http://www.plctalk.net/qanda/showthread.php?t=75397 http://manuali.eltex.biz/Manuali_LENZE/Software_manuali/Drive%20PLC%20Developer%20Studio/PLCs/SW_DDS_DrivePLC_v1-1_EN.pdf Look up 5.1.5 Programming / 5.1.4 Commissioning in the above manual. It will explain how to connect to the controller. Hope this helps you out. Regards,
http://www.plctalk.net/qanda/showthread.php?t=75397 http://manuali.eltex.biz/Manuali_LENZE/Software_manuali/Drive%20PLC%20Developer%20Studio/PLCs/SW_DDS_DrivePLC_v1-1_EN.pdf Look up 5.1.5 Programming / 5.1.4 Commissioning in the above manual. It will explain how to connect to the controller. Hope this helps you out. Regards,
Mad_Poet Member OP M Join Date Feb 2017 Location Virginia Posts 375 Aug 22, 2017 #3 Many thanks. Poet.