Telmecanique PLC TSX-17 - Problem....

darshan

Member
D
Join Date
Dec 2005
Location
puna
Posts
1
Hi all,

(Telmecanique PLC TSX-17 )
HEC-FX417-Schinider's 9-pin end was connected to IO extension port of PCL by mistake. The HEC was off and suddenly the plant got shutdown. PCL reads "MD".
No other indications appearing even after switching ON/OFF several times. Can any one pl guide what is "MD"? Is it possible to get PLC back into operation ? How? Is it possible that the memory got crashed ? Where I can get the software for this PLC if sw is crashed ?

The EPROM is PL-74V20. How to recover program from this?
No catalogue is available & where can I get a detailed catalogue ?

Can anybody provide the cable & connection details Pl.

Thanks
 

Similar Topics

S
Siemens PLC Main Disconnect Trip
The past week we received a new piece of equipment from Germany which utilizes siemens controls. Typically in our company we use A.B. controls for...
Replies
4
Views
32
joseph_e2
J
N
Conveyor PLC
the conveyor can stop because of a safety sensor or safety switch. And also it can stop because of an object jam detector sensor. If the conveyor...
Replies
5
Views
108
geniusintraining
geniusintraining
T
PLC Delta DVP 12SE and HMI Kinco GL043E not propperly connecting
Good Day to all of you, this is my first post, i will try to explain as best as possible, english is not my natural language. I am performing an...
Replies
0
Views
29
Tecnolaundry
T
Mas01
S7-TIA Portal: How can I make a project if I've only got the code loaded on the PLC?
Hi All, Someone at work has put a PLC system on my desk, that's just been taken off an idle production line. He said "It's an S7 PLC. We don't...
Replies
10
Views
188
bkottaras
B
A
ATS using a PLC
I have a project to automate four generator sets. The system will monitor and store the load demand of the factory. Once there's Power outage, the...
Replies
0
Views
55
Alibaba07
A
Back
Top Bottom