motion control using RSlogix5000

tj5nguyen

Member
T
Join Date
Jan 2006
Location
Longview, WA
Posts
3
I have trouble to get a Process Complete bit to turn on after a MAM. This only happens on one of the many MAM commands on the same axis. Could axis tuning be a problem? I notice that my axis run very slow to what I want it to run.
 

Similar Topics

A
using HSC in motion control with PTO drive
Hi Everyone am controlling a stepper motor with 1215 plc, when using motion control(V6/7) you don't have any option of using HSC as feedback is...
Replies
0
Views
909
adam_lhadi
A
T
motion control using RSlogix5000
I could not get a PC (process complete) bit to turn on after a MAM command. This only happens on one of the many MAM commands on the same axis...
Replies
3
Views
3,469
Peter Nachtwey
Peter Nachtwey
H
Motion control use torque loop in Rockwell Studio 5000
I have always controlled servos in Rockwell motion using position loop. I have an application where one process will push against a servo...
Replies
3
Views
269
robertmee
R
D
Motion control parameters
How do I adjust motion control parameters using Logix Designer? Such as: motion axis stop I will make an adjustment like changing the...
Replies
1
Views
320
chavak
chavak
M
CompactLogix 1769-L33ER Motion Control Axis in fault.
Hey guys, On my system, i got prop valve controling cylinder on the left and right to adjust the center of a lumber before it get in a woodmill...
Replies
8
Views
918
mike3475
M
Back
Top Bottom