Hi Guys,
I am heading to a site next week that has some old ScadaPacks (they are labelled Control Microsystems). I have the original programs (.LAD file). I contacted ScadaPack (Schneider Electric) to see if there was a way to tell what revision this file was and if the software was still available. Long story short, I was able to open with TelePace 3.40, Save and then open with TeleStudio 5.08.
Now according to the the person I spoke with at Schneider, I will be able to connect to the old ScadaPack, go on-line, make modifications ect using TeleStudio 5.08 without any issue.
Is this the case? Can someone please verify for me that I am not going to brick this ScadaPack because I used the wrong version and/or software.
Thank You
I am heading to a site next week that has some old ScadaPacks (they are labelled Control Microsystems). I have the original programs (.LAD file). I contacted ScadaPack (Schneider Electric) to see if there was a way to tell what revision this file was and if the software was still available. Long story short, I was able to open with TelePace 3.40, Save and then open with TeleStudio 5.08.
Now according to the the person I spoke with at Schneider, I will be able to connect to the old ScadaPack, go on-line, make modifications ect using TeleStudio 5.08 without any issue.
Is this the case? Can someone please verify for me that I am not going to brick this ScadaPack because I used the wrong version and/or software.
Thank You