We have a GE Fanuc 90-30 that will lose it's program after weekend shut down. This has happened a few times and we changed the battery last week, did not have a low battery light, and it still happened again today. We noticed today the controller time was reset to 1-1-2000, we corrected it to the current time.
We are getting 2 faults every time we restart this controller.
0.10 Module Hardware Fault
Error Code 479
Error Code 486
We clear them, restart the controller, and they come right back.
We are getting 2 faults every time we restart this controller.
0.10 Module Hardware Fault
Error Code 479
Error Code 486
We clear them, restart the controller, and they come right back.