Hi guy's im trying to figure out how to turn an encoder signal into a speed reference or a tachometer in slc 500, has anyone done this? im using an ab micrologix 1400 a pf525 drive and my encoder makes 500 ppr, I want to convert these pulses into rpm's or in/min. I want to tell a 525 drive through messaging in slc 500 to run within a speed window, the speed of the material im measuring increase as my take up roll gets larger so i need to dynamically decrease speed on the fly.
creating a speed reference from an encoder?
- Thread starter bobbas41
- Start date
http://www.plctalk.net/qanda/showthread.php?t=49564
http://www.plctalk.net/qanda/showthread.php?t=72447
The above links may help you out.
Regards,
http://www.plctalk.net/qanda/showthread.php?t=72447
The above links may help you out.
Regards,
Similar Topics
The idea here is to provide for a brief rapid influx of message codes while preventing sequentially repeating the same message.
i.e. if two...
Hello everyone,
In a factory where we installed Citect 7.20 the computer began to show the first signs of end of life. They never considered...
Hi everyone,
I'm a last year student at the university in Ghent, and for my thesis i need to write a TwinCAT program that writes data to a .daq...
When I go to create a new module in Studio 5000 I can't enter any information for the IP Address or change any other fields. Is there any fix to...
Hello
I am kind of new to the Rockwell world, i've mainly worked with Siemens and Schneider untill now.
I am to make a HMI application running...
