Controllogix & Markem-Image SmartDate X40

Yasir Maqsood

Member
Y
Join Date
Jul 2018
Location
Pakistan
Posts
3
I am working on a project where i need to communicate Markem-Imaje SmartDate X40 with Allen Bradley ControlLogix PLC over Ethernet. The requirement is to change the Job Number from PLC. If anyone has experience on this particular application, please share the procedure.



Yasir Maqsood
 

Similar Topics

Y
Controllogix & Markem-Image SmartDate X40
I am working on a project where i need to communicate Markem-Imaje SmartDate X40 with Allen Bradley ControlLogix PLC over Ethernet. The...
Replies
0
Views
1,306
Yasir Maqsood
Y
F
Controllogix & Markem-Image NGPCL Protocol over Ethernet
We've had this working over RS232 for several years using AWT and ARD ASCII commands in the Controllogix program. Markem has now unleashed an...
Replies
7
Views
11,140
valer85
V
D
Markem imaje with Controllogix
Anyone work with this printer and interface with a Controllogix platform? I am assuming ethernet IP with MSG instructions but I could be wrong...
Replies
2
Views
1,907
Jeev
Jeev
T
ControlLogix Redundancy Module Single Mode Fiber
Why does the controllogix redundancy modules use a single mode fiber vs multimode fiber?
Replies
1
Views
46
Ken Moore
Ken Moore
B
ControlLogix IB16IF and OB16IEF
Hello, I have two 16 point input cards and 1 16 point output card showing module faulted on my IO tree in Logix Designer. The fault code is...
Replies
7
Views
201
Contr_Conn
Contr_Conn
Back
Top Bottom