How to receive program from SattCon OP45 PLC

AmenAllah

Member
A
Join Date
May 2016
Location
Tunis
Posts
1
Hello,

My task is to upgrade a control system based on SattCon OP45 PLC to a Simatic control system.

I have some questions :

1- What is the appropriate software, DOX5 or DOX10 ?
2- And how to receive program from PLC in both of cases ?
3- Can I use RS232 DB9 to DB25 cable to ensure communication between SattCon and PC ?

Thank you :)
 

Similar Topics

P
Receive data through 1734ASC
Hi guys, I am using asc protocol to communicate to a inkjet printer and having issues receiving response from printer. It send me data but plc...
Replies
0
Views
86
Paras_rag
P
S
Issue about Mitsubishi plc receive serial communication package
Currently,we are facing the communication go through with 422 tx+ and tx-. Mitsubishi fx5u series is used and using command rs2. But the package...
Replies
0
Views
101
Sohaboss4
S
B
Does Rockwell Automation have an Input that will receive an input from a Load Cell
Good Afternoon , Does Rockwell Automation have an Input Card , maybe in the 1734 series , or CompactLogix series that will receive signals...
2
Replies
15
Views
820
busarider29
busarider29
R
The temperature controller connected to the CH2 channel cannot receive the parameter
Hello . The PLC is Mitsubishi's QJ71C24N-R4. Communicates with 39 temperature controllers using an unordered communication protocol. CH1 channel...
Replies
0
Views
473
Robin1239544299
R
E
Can a DINT receive a decimal-ed value?
I was with tasked with making a modification to a current HMI project and found that a Numeric Input on the HMI was writing to a DINT in the PLC...
Replies
5
Views
2,570
janner_10
J
Back
Top Bottom