Power up s:1/15

I think you hit the nail, I looked at HMI and had switch as (set on) Weintek
instead of momentary. I will upload tonight and watch online.
 
mylespetro said:
What I usually do is have the first pass bit enable a timer with a preset of 0.5 sec just in case it doesn't trigger, but that's usually in front of logic that's a little more involved. Just ensures that the following logic sees the first pass bit go true.
Click to expand...


Just want to clarify, the first pass enables a TOF timer, not a TON.
 

Similar Topics

S
Modbus TCP connection between my plc and a power meter on TIA Portal
Hello gentlemen, Im working on a small project on TIA Portal, about establishing a Modbus TCP connection between my ET200SP plc and a socomec...
Replies
10
Views
214
Steve Bailey
Steve Bailey
T
Power Supply Protection
I have the power supply in the link below. If we want a breaker to isolate and protect the input side how would I size that correctly being 120...
Replies
8
Views
185
JesperMP
JesperMP
S
Power Flex 527 , safety inhibitor fault
Power flex 527 Network based safety drive had faulty and alarm pop up SOS Code internal fault Unable to set or clear the fault manually or...
Replies
5
Views
106
arpus4KM
A
N
24VDC Class 2 Power Supplies
We normally ground the -24VDC side of a control systems power supply. What are you folks thoughts about grounding the -24VDC side of a class 2...
Replies
1
Views
106
OkiePC
OkiePC
M
Honeywell / EnergyICT EIM Flex Power Meter
Hi all. Would anyone happen to have the Modbus register datasheet for the Honeywell/EnergyICT EIMFlex Modular Meter v1.11 We've 40 of these that...
Replies
0
Views
60
muzanz
M
Back
Top Bottom