Siemens drive

Hi,
I have siemens drive with technological board T400. I am un able to find technological parameter L503 or H605 in siemens stander drive software. I want to know is there any special software for access of parameter on CU board USS protocol.
Best regards,

When you create a drivemonitor file, there is a dropdown selection for Technology Type. Try creating a new DriveMonitor file and select T400 from that list.

In the Siemens MasterDrives . . .
There is a parameter, and I forget which one, which, depending on what is in it,
will enable or disable other parameters.
MadPoet.

I just pick the correct fw on both CU and T400 and connect
What software is on the T400? SPA, SPW..SPS or custom??
Look on the side of the board or d1 and d2 values in T400