Hi All,
When I try to run my project, it goes into runtime without any faults, and shows in the WinCC explorer that it is active, however in the actual runtime, I don't see any text in the buttons for the hierarchy, and at the top (where the alarms normally come) it shows 'not active.
I tried several other projects, which I'm sure of that where working fine, with the same result.
I'm not 100 percent shure but I think this happened after I installed a hotfix for WinCC flex.
The projects that I tried are PCS7 project V7.0 with WinCC V6.2.
Any suggestion before I reinstall all the software...
Much appreciated
When I try to run my project, it goes into runtime without any faults, and shows in the WinCC explorer that it is active, however in the actual runtime, I don't see any text in the buttons for the hierarchy, and at the top (where the alarms normally come) it shows 'not active.
I tried several other projects, which I'm sure of that where working fine, with the same result.
I'm not 100 percent shure but I think this happened after I installed a hotfix for WinCC flex.
The projects that I tried are PCS7 project V7.0 with WinCC V6.2.
Any suggestion before I reinstall all the software...
Much appreciated