Hi
i have a problem before with the PLC power supply,and i have got it changed by new one,upon power up the system again the cpu goes normal to run mode
but while using to start the operation from the HMI screen (for example to start a motor) no have any action at all,so any one have experience with same problem before i will be grateful if you share it
i have a problem before with the PLC power supply,and i have got it changed by new one,upon power up the system again the cpu goes normal to run mode
but while using to start the operation from the HMI screen (for example to start a motor) no have any action at all,so any one have experience with same problem before i will be grateful if you share it