PWS3261/HMI/HItech

msalman

Member
M
Join Date
Mar 2018
Location
ibd
Posts
4
help required to download program PWS3261 HMI and connect with RS232C port of PLC,
cheksum error in start(firmware problem?),
without removing checksum error ,making single button and compiling program then only application download working but no display on hmi on run,
download firmware and application not working shows timeout error
dip switches, 5 and 6 off only other all on
please help
 

Similar Topics

R
HiTech PWS3261 HMI
I am not familiar with Hitech HMI. I had to replace a defective screen with a new one. Screen was not readable on the old one and it displayed...
Replies
2
Views
3,298
andybutcher
A
B
HMI GRAPHICS MISSING_WINCC UNIFIED V18.UPD3
Does anyone happen to know how to install the graphic picture in HMI when I go into blower selection there are no graphics shown not only blower...
Replies
1
Views
50
Jkoso
J
B
HMI GRAPHICS MISSING
Does anyone happen to know how to install the graphic picture in HMI when I go into blower selection there are no graphics show not only blower...
Replies
1
Views
73
Mark-
M
C
Air Conditioning for HMI
Hello All, I've been tasked with automating a flatbed press that runs with some pretty extreme temperatures. I've been told it can run close to...
Replies
4
Views
143
cm-nonwov
C
F
FactoryTalk HMI Question (Recipes)
Good morning! Let me start by saying, I am still learning about this type of HMI programming. I recently watched a video about recipes and how it...
Replies
0
Views
55
Foxtrot2050
F
Back
Top Bottom