Setup:
- Schneider Electric M340 PLC w/ NOE 100 Module installed
- Allen Bradley PowerFlex 753 VFD w/ 20-COMM-M Modbus Adapter installed
- Protocol - Modbus TCP/IP
Objective:
Communicate via IO Scanning to PowerFlex Drive for Logic Status/Command and Reference
My question is has anyone had anyone tried this setup and had any luck? Or does anyone with "higher intelligence" than me have any ideas on how to implement this.
I configured the IO Scanner Line as follows:
IP - IP setup in the 20-COMM-M on the drive
Unit ID - 255
Slave Syntax - Modbus
Health and Repetitive Rate - Default
I used a IO Scanner line each for read and write addresses.
Any help is appreciated.
- Schneider Electric M340 PLC w/ NOE 100 Module installed
- Allen Bradley PowerFlex 753 VFD w/ 20-COMM-M Modbus Adapter installed
- Protocol - Modbus TCP/IP
Objective:
Communicate via IO Scanning to PowerFlex Drive for Logic Status/Command and Reference
My question is has anyone had anyone tried this setup and had any luck? Or does anyone with "higher intelligence" than me have any ideas on how to implement this.
I configured the IO Scanner Line as follows:
IP - IP setup in the 20-COMM-M on the drive
Unit ID - 255
Slave Syntax - Modbus
Health and Repetitive Rate - Default
I used a IO Scanner line each for read and write addresses.
Any help is appreciated.