Hi,
I'm having difficulty configuring the ethernet card on on our Omron CJ2H-CPU66 rack.
Using the PLC IO table to configure the ethernet card, CX-Progr will not verify the target ethernet card (cj1w-etn21) due to a mismatch between the version of my PC and target.
Target version = 1.4
PC version = 1.5
A screenshot of the error message is attached.
My questions are:
1. How do i get the two version numbers to match?
2. There is no where on the menu that in the PLC table that lets me adjust the version number
3. Do I need upgrade the firmware of the target card, if so - how?
4. Or do i need to update the product catalog on my Cx-prog? - How ?
CxProg version = v9.31
Any advise appreciated.Thanks guys.
I'm having difficulty configuring the ethernet card on on our Omron CJ2H-CPU66 rack.
Using the PLC IO table to configure the ethernet card, CX-Progr will not verify the target ethernet card (cj1w-etn21) due to a mismatch between the version of my PC and target.
Target version = 1.4
PC version = 1.5
A screenshot of the error message is attached.
My questions are:
1. How do i get the two version numbers to match?
2. There is no where on the menu that in the PLC table that lets me adjust the version number
3. Do I need upgrade the firmware of the target card, if so - how?
4. Or do i need to update the product catalog on my Cx-prog? - How ?
CxProg version = v9.31
Any advise appreciated.Thanks guys.
