Omron Servo drive

Hi,

I have some question relate with Omron servo drive

I am using CJ1W-NC271 position control unit for servo drive
In the CX-MOTION- NCF, I setup driver(R88D-KN04L-ML2) memory area on CIO 1025 as output, CIO 1125 as output

But how can I know which bit is for jog or speed command

where can I find manual for that?

Thanks

Kyle

http://www.miel.si/wp-content/VsebinaPDF/W426-E1-10+C_1W-NC+OperManual.pdf

The above manual should help you out.
4-7 Axis Operating Output Memory Areas - This will tell you the areas to look at for the information to control the drive.

Regards,

gclshortt said:

http://www.miel.si/wp-content/VsebinaPDF/W426-E1-10+C_1W-NC+OperManual.pdf

The above manual should help you out.
4-7 Axis Operating Output Memory Areas - This will tell you the areas to look at for the information to control the drive.

Regards,

Click to expand...

Thank you so much.

I read it. it's really helpful.