TimD
Lifetime Supporting Member
Hi, I am going to build a small 2-starter motor control panel. I have built three phase starter panels before, but this is my first, using 230v single phase motors.
Granted, I'm no electrician, I like a lot of programmers like 24vdc! I probably shouldn't build this, but I've done a dozen three phase panels already, and this is small, and I'll learn something...
This panel will be inspected by a licensed electrician prior to service.
I have 2 questions:
#1 Should I use double or single pole breakers to protect the motors?
#2 If my service is 230v, is there an easy way to get 110v for my controller without using a transformer?
Thanks very much!
Tim
Granted, I'm no electrician, I like a lot of programmers like 24vdc! I probably shouldn't build this, but I've done a dozen three phase panels already, and this is small, and I'll learn something...
This panel will be inspected by a licensed electrician prior to service.
I have 2 questions:
#1 Should I use double or single pole breakers to protect the motors?
#2 If my service is 230v, is there an easy way to get 110v for my controller without using a transformer?
Thanks very much!
Tim