PPI Network with Radio Modems

robertopsilva

Member
Join Date
Oct 2003
Location
Fortaleza - Northeast of Brazil
Posts
12
I have 16 PLC´s S7-200 CPU 224, each one connected to a HMI TD-200. I need to connect all of them to a SCADA using radio modem transmition. The radio I´m going to use is a MDS spread spectrum in transparent mode, RS-485 port. Is it possible to use PPI Protocol for this application?
 

Similar Topics

Hello, I have a PPI-network with a laptop with Microwin software and a Siemens S7-222 plc and an operator panel ESA VT150W. Problem is when I...
Replies
0
Views
1,407
Hello everyone. I have a question, because I searched the internet and I couldn't find anything about it. I have two pc-ppi cables. The one...
Replies
6
Views
1,657
Good morning, my customer is looking for a contractor that can service a customer in Batesville MS. The immediate need is for someone to go in...
Replies
0
Views
1,310
Dears, I need the configuration of the PPI cable suitable to connect RS232 PC side to RS 485 PLC(S7-200) side to download a project via MicroWIN...
Replies
15
Views
5,347
hello sir, I am using SIEMENS USB/PPI cable 6ES7 901-3DB30-0XA0 for s7-200 plc.But unfortunately its cable broken from RS485 side 9 pin...
Replies
0
Views
952
Back
Top Bottom